Best Car Cleaning Tips and Tricks
Simple ways to get your car looking almost brand new!
Wash With the Right Suds
Even though hand dishwashing liquid is a great degreaser, it’s not the thing to use on your vehicle’s finish. Yes, it removes dirt, grease and old wax. But it also sucks important oils right out of the paint’s finish. Use it repeatedly and you shorten the life of your paint job. Instead of dish soap, use a cleaner formulated for vehicles (available at any auto parts store). Once you’ve mixed the suds, go one step further—fill a second bucket with clean rinse water. Use it to rinse the wash mitt often. That’ll remove most of the road grit from the mitt to prevent scratches. Then throw the mitt in the washing machine to get it completely clean. When you’re finished, take a few more steps to protect your car’s finish.
Pluck the Finish
Polish the Finish
Many car owners confuse polishing with waxing. But they’re separate steps. Polishing removes small surface imperfections and scratches and buffs the finish to a shine. Waxing adds more gloss and protects the finish from the elements. Most DIYers skip polishing because they don’t want to invest the money for a polisher or the elbow grease for a hand polish. But polishing your vehicle’s finish is the key to getting the best gloss (pros would never skip it). Apply a dollop of polish to the pad and wipe the pad across a 2 x 2-ft. area. Run the polisher at a slow speed to spread the compound over the entire area. Then boost the speed and let the polisher do the work for you.
Get a Mirror Finish With Synthetic Wax
Some people swear by carnauba wax. It produces a deep, warm shine. But we prefer the wet-gloss look of the newer synthetic polymer waxes (also known as paint sealant) such as Meguiar’s Ultimate Liquid Wax. It’s pricier than other synthetics, but it doesn’t leave a white film on plastic or trim—which is a real advantage. Plus, it’s really easy to apply. Apply the wax to the foam applicator and rub it into the finish with a swirling motion. Then wipe off the haze with a microfiber towel. Swap in a clean towel as soon as the first one loads up.
Suck Up the Dust As You Go
Most DIYers start cleaning the interior by shampooing the carpet. That’s a mistake—you’ll just get it dirty again as you clean the upper surfaces. Instead, start at the top and work your way down. Vacuum the headliner, dash, console and door panels. Then clean all the glass, and dust the nooks and crannies. Sweep the dust out of the cracks with a detailing brush. Catch all that crud right away with your vacuum. Read about how to clean and restore your car’s interior.
Destink the Interior
Clean the Leather
Slide Seats Forward and Clean Out the Junk
You’ll be surprised by what you find behind the seats. We found a lost cell phone, enough pens and pencils to equip a small office, and enough change for several vending machine lunches. Vacuum the seats, remove the mats and vacuum the carpet. Use a brush attachment for the dash and door panels. Don’t forget to clean out and vacuum those handy door pockets (another source of buried treasure). Learn how to get the best vacuum for the job.
Deep-Clean Carpet and Upholstery
Use a carpet cleaning machine to get the deep dirt that settles into the fibers of the carpet. (Clean cloth seats this way as well.) It sprays the carpet with a solution of water and cleaner and then sucks the dirt and grime into a reservoir. A machine like this pays for itself after just a few uses. You can also rent one from a rental center or use a spray-on cleaner and a scrub brush instead.
Scrape Off Those Annoying Stickers
Wash the Windows, Including the Top Edges
Ever notice that line of grime on the tops of windows when they’re partially rolled down? Most people overlook this detail when giving their vehicle a quick wash. A few minutes with Windex and a clean rag is all it takes. Power windows not working? There’s an easy repair.
Brush Out the Air Vents
Remember to Clean Nooks and Crannies
Detailing means just that—finding and dealing with all the trim lines and recesses that a quick once-over cleaning job misses. Wrap a cloth around an old, worn screwdriver (without sharp edges) and spray Simple Green or other all-purpose cleaner on the cloth. Move it gently along the trim lines to pick up the gunk. Keep refreshing the surface of the cloth. Go around all the buttons and controls as well. Follow up with a rejuvenator like Armor All.